The section describes special attention notes that indicate changes in functionality that require you to update models, cause model results to differ, or display a warning message when you first load a model in RiverWare 8.2. Also listed are important known issues.

If you have any questions, contact RiverWare Support:

An error condition was identified when an input DMI containing a DSS dataset attempts to import data from a DSS file saved in version 7. For certain types of data, the import fails with a read error. This is filed as issue RW‑6549. CADSWES plans to address this issue in the next few months. In the meantime, as a workaround, you can save the version 7 file in the version 6 format in DSSVue.

The RPL function ObjAcctSupplyByWaterTypeRelTypeDestType returned incorrect supplies due to an inadvertent change in RiverWare 8.0. The fix to RW‑6546 restored the function to its original behavior.

The following slots were added to the methods in the Operating Levels and Surcharge Release categories:

These time series slots hold the storage at the appropriate operating level. The slots were added for performance reasons; instead of accessing the periodic operating level table slots each time, these new slots are used for quicker access. In some long-term planning models, the run time improved by three percent. In certain situations, these new slots could lead to new error conditions or different results in the Operating Level slots.

For more information on these slots, see Operating Levels in Objects and Methods.

The following two items were identified requiring special attention when using the Slope Power Reservoir Weighting Coefficients method.

The fix to RW‑6534 resolved a computation error affecting slope power reservoirs that use the Weighting Coefficients method in the Slope Storage Coefficients method category. When a RPL predefined function operating on a reservoir, such as SolveSlopeStorageGivenInflowOutflow or GetMaxOutflowGivenInflow, passed an inflow value as an argument, the computation incorrectly used the Inflow slot value when it applied the Profile Storage Coefficients for the current timestep. When the Inflow slot value was NaN, the computation incorrectly used zero. The computation now correctly uses the inflow value from the function as intended.

A potential issue was identified for slope power reservoirs that use the Weighting Coefficients method. If a value is NaN for Inflow, Outflow, or Hydrologic Inflow for any previous timestep corresponding to the number of Partition Profile Coefficients, when the object dispatches, a zero value is used instead of NaN. This is most likely to occur when values are NaN for pre-simulation timesteps, and it can produce incorrect results. See Weighting Coefficients in Objects and Methods for details on the potential effects.