skip to main content
Release Notes : Release Notes, Version 8.5 : What’s New in Version 8.5 : Run Control
Run Control
The following changes have been made to the Run Control.
Pause Before First Timestep
Previously, in runs that use Run Cycles, there was no way to pause before the first timestep in Run Cycle 2, 3, and so on. This restriction has been removed and you can now “Pause Before Timestep” for any timestep in the run.
For more information, see Making a Run in User Interface and Run Cycles in Solution Approaches.
Specify Optimization Restore Point
When the Optimization Controller is selected, an option is now shown to specify the use of a Restore Point for an advanced start. See Optimization Restore Points for Advanced Start for more information.
Figure 1.12  Screenshot of Run Control and new Run From Restore Point
Revised: 07/05/2022