skip to main content
Optimization
The following changes were made to Optimization.
Optimization Diagnostic Changes
The following changes were made to Optimization Diagnostics to reduce the volume of messages automatically issued so that greater attention is given to the remaining messages, which are of relatively higher importance.
• Percent Satisfaction Messages: Previously, every goal that contained a derived objective to maximize the satisfaction of soft constraints reported the objective value, which is the percent satisfaction of the constraints. Now the message about the percent satisfaction is automatically written to Diagnostics only if the satisfaction is less than 100%, in other words, only for goals with soft constraints that were violated. The percent satisfaction for all goals can still be printed by enabling Informational Diagnostics for Optimization and selecting the new Objective Values category in the Optimization Diagnostics Settings. In addition, the percent satisfaction for all goals can still be easily viewed in the Priority-oriented Optimization Solution Analysis Tool (POSAT).
• Minimize and Maximize Objective Values: Messages reporting the objective value for Minimize and Maximize objectives are no longer written automatically to Diagnostics. The objective values can optionally be printed by enabling Informational Diagnostics for Optimization and selecting the new Objective Values category in the Optimization Diagnostics Settings along with the appropriate goals. In addition, the objective value for all goals can still be easily viewed in the Priority-oriented Optimization Solution Analysis Tool (POSAT).
• Power Plant Cap Fraction Warnings: For the Plant Efficiency Curve and Plant Power Coefficient methods in the Power category on Power Reservoirs, a warning is issued at the start of an Optimization run if the Power Plant Cap Fraction slot value is greater than 1.0. These messages were improved in the following manner.
– The warning is printed automatically only once per run for a given reservoir object, for the first timestep at which the Power Plant Cap Fraction is greater than 1.0.
– The warning message was improved by adding the reservoir and timestep to the message.
– Similar messages for subsequent timesteps with a Power Plant Cap Fraction greater than 1.0 can be printed by enabling Informational Diagnostics for Optimization and selecting the Variable Approx. Data category in the Optimization Diagnostics Settings.
– Similar messages about a Power Plant Cap Fraction greater than 1.0 in a Simulation or Rulebased Simulation can be printed by enabling Informational Diagnostics for and selecting the User Methods category in the Simulation or Rulebased Simulation Diagnostics Settings.
• Initial Value Checks for Approximation Points: Previously a warning would be issued if an approximation point (a value in a LP Param table slot) deviated from the value for the associated slot variable on the Initial Timestep by more than a maximum threshold. These diagnostics were modified in the following manner.
– The messages are no longer printed automatically as warnings but instead have been changed to Informational Diagnostics, which can be printed by selecting the Variable Approx. Data category in the Optimization Diagnostics Settings.
– Instead of comparing the approximation point with the Initial Timestep value for the slot variable, it now looks for the “last known value” by starting at the Initial Timestep and advancing in time until it encounters a NaN and then using the previous timestep’s value.
– Text was added to the message to indicate that a large deviation between the approximation point and the variable’s last known value could contribute to infeasibility.
• Outlet Capacity Constraint Warnings: Previously warning messages were issued for some outlet capacity constraints, for example Bypass Capacity, because they were no more restrictive than the slot bounds for the associated variable. These messages were eliminated because they did not provide useful information.
More information about Optimization Informational Diagnostics can be found at Optimization Diagnostics in Debugging and Analysis.
More information about the Priority-oriented Optimization Solution Analysis Tool (POSAT) for viewing objective values and constraint satisfaction can be found at Priority-oriented Optimization Solution Analysis Tool in Optimization.
Warnings from Removal on Non-Visible Methods
See the Special Attention Note about Warnings from Removal of Non-Visible Methods.
Revised: 11/12/2026